|
HO - Other
Products
DCC Information
To isolate the
motor brushes on an OLD Bowser DC-71 motor
(Old DC-71 had only one wire and half the brush plate is
brass)
a new brush plate (#22193) required to replace the brass
plate on the motor.
All our kits using
the DC-71
motor have the DCC compatable motor.
Skew wound armature, straight polished shaft, new magnet
material, double insulated brushes for easy DCC.
I like an O Scale DCC module for Bowser Steam Locos.
They will fit in the tenders.
|
These motors
will be discontinued
when supply is exhausted.
DC-60, 65, 77, 81, 84. |
Old DC-71's with one brush
grounded. For
DCC insulate brushes use #22193 insulator |
 |
|
 |
|
DC-60 MOTOR
.0019 HP at 9800 RPM.
Dimensions: 1 7/8 long x 3/4" wide x 7/8" high; 3/32 shaft extending
approximately 5/8".
Wound for 12 volt DC operation. |
|
DC-77 MOTOR
.0034 HP at 13,900 RPM.
Dimensions: 1 7/8 long x 11/16" wide x 1"
high; 3/32 shaft extending approximately 1/2".
Wound for 12 volt DC operation. |
|
 |
 |
 |
|
DC-81 MOTOR
.0055 HP at 7,000 RPM. Dimensions: 2 5/6" long
x 13/16" wide x 1" high; 1/8" shaft extending
approximately 1/2". Wound for 12 volt DC
operation. |
DC-65 MOTOR
.0034 HP at 14000 RPM. Dimensions:
1 7/32 long x 1 5/64" high x 3/
4 wide" x 7/8" high; 3/32 shaft extending
approximately 1/2". Wound for
12 volt DC operation. |
DC-84 MOTOR
.009 HP at 9,500 RPM. Dimensions:
1 11/16" long x 1 11/16" wide x 1 3/8"
high; 1/8" shaft extending approximately
1/2" on both ends. Wound for 12
volt DC operation. |
|
Digi
Traxx
Alco Century 628 and 630 - DH 163IP, DH163D, DH163P
DH123P, DH123D
GE U25B - DH 163IP, DZ143PS DZ123PS, DH163K0, DH142
DH123D
EMD FT - DH 163IP, DH163K0 DH123D
EMD F Units - DH 163IP, DH163P DH123P
Baldwin AS16 DH163K0, DH142 DH123D
Baldwin AS-616 DH163K0, DH142 DH123D
Baldwin RS-12 DH163K0, DH142 DH123D
Baldwin VO1000 DZ143PS DZ123PS
Baldwin S-8 DZ143PS DZ123PS
Baldwin S-12 DZ143PS DZ123PS
Baldwin VO-660 DZ143PS DZ123PS
Baldwin DS-4-4-1000 DZ143PS DZ123PS |
